Wall bracket
INSTALLATION INSTRUCTIONS
1. Read and understand instructions and warnings before proceeding with the installation.
2. Be sure building structure is stable and all the walls are completely erected and secured.
3. The brackets should be a distance of 10’ (3 m) maximum, center to center.
4. Install a spacer between the inner side of the wall and the bracket elbow to prevent any movement.
5. The bottom rail of the bracket must overlap at least two studs, one on both sides of the central section of the
support. Fasten the bottom rail to the studs with #10 x 2 1/2" (6.5 cm) screws or 3 1/2" spiral nails.
6. Install a scaffold plank deck. Use 2" x 10" x 12’ (5 cm x 25 cm x 3.65 m) Certified planks. The planks must
overlap at least 1’ (30 cm) on each side of the brackets.
7. Install guardrail post and lock it using the locking pin provided or use a 3/8" x 2" (0.95 x 5 cm) bolt with nut.
8. Install a toeboard using 2" x 10" x 12’ (5 cm x 25 cm x 3.65 m) scaffold plank. Toeboards must overlap at least
1’ (30 cm) on each side of the brackets.
9. Install a top and lower rail using 2" x 6" x 12’ (5 cm x 15 cm x 3.65 m) planks. Top and lower rails should
overlap at least 1’ (30 cm) on each side of the brackets.
10. Each installation step must be executed safely and in accordance with federal, state or provincial (CSST) and
municipal regulations.
11. During disassembly, do not let wall bracket components fall on the ground.
12. After each use, perform a visual inspection to ensure proper functioning and integrity of all components of
the bracket. Do not use equipment if not in good condition.
______________________________
warning
FAILURE TO UNDERSTAND AND FOLLOW ALL SAFETY RULES AND ASSEMBLY INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
USER ASSUMES RISK OF PERSONAL INJURY BY FAILURE TO READ AND FOLLOW MANUFACTURER’S SAFETY RULES
AND ASSEMBLY INSTRUCTIONS, AND BY FAILURE TO OBSERVE FEDERAL, STATE OR PROVINCIAL AND MUNICIPAL
CODES.
- A wall bracket must be erected, altered, and dismantled by qualified workers or under the direct supervision
of a qualified person. The qualified person must ensure that the erection is carried out properly, and that the
correct components and materials are being used.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals